With 7.0 inch touch screen system, 4 way water quality sensor, 3 way flow sensor for quantified dispensing, Ionpure EDI module, built-in TOC module, 2 stage RO and 3 pump system, Super series is top choice of ultrapure water for high grade experiments.
With tap water inlet, its output is 10 liters/hour. It can produce Edi water and ultrapure water. The Edi water’s resistivity is above 5MΩ.cm, and the ultrapure water’s resistivity absolutely reaches to 18.2MΩ.cm. It completely meets the highest grade I standard of ASTM, CAP, CLSI, EP and USP.
Models:
Super 10
Super 10F
Super 10V
Super 10FV
Super-TOC 10V
Super-TOC 10FV
Features and Advantages
Colorful touch screen 7.0 inch colorful high-resolution touch screen (16:9) controlling system, achieve finger-touch new experience. |
|
Comprehensive monitoring system 4 way online water quality sensor, detect the quality of feed water, 2nd stage RO water, Edi water and ultrapure water respectively. And warn once water quality´s standard exceeding. 3 way flow sensor, count source water consumption and achieve quantified dispensing of Edi and ultrapure water. |
|
Integrate with Ionpure EDI module Without softener, chemical regeneration and replacing any DI cartridge, its pure water´s resistivity will be above 5MΩ.cm(25°C), and TOC is lower than 30ppb. It will reduce the running cost and emissions of waste water. The maximum output is 240 liters per day. |
|
Double stage reverse osmosis technology With 2 pumps, 2 RO membranes and buffer tank, system assures 2nd stage RO water quality´s stability from different source water, and achieves little drain and low running cost. |
|
Built-in 3 pump system 1st stage RO pump, 2nd stage RO pump and circulating sanitizing pump |
|
Built-in online TOC monitor module (TOC model) Independent TOC monitor module It can be taken out to monitor any other ultrapure water |
|
All Cartridges replacing alarm function, based on time, flux and water quality, show cartridges´ used and residual life.
Multiple alarm function: no feed water, full water, water quality´s standard exceeding, cartridge life ending and leakage.
Auto self-flushing of RO membrane function (interval and continuous time setting), extend RO membrane´s life.
Auto running data storing function with built-in SD card, and data can be exported through the USB interface.
System continuous upgrading function through USB interface, and WIFI module is optional.
Built-in perpetual calendar clock for cartridges and service setting.
System sanitizing procedure, achieve the disinfection of ultrapure water´s tube and valve.
System circulation function, achieve ultrapure water´s circulation to keep top quality of ultrapure water.
Level II password, protect all the parameters setting, and prohibit any unauthorized setting change.
Attached 50 liters water tank with conical bottom, including air filter, to prevent co2 and bacteria. Also external tanks is optional.
Whole plastic shell with high-strength, avoid rusting and keep clean, to meet GLP standard.
4 door and easy-to-replacing cartridge design, convenient to maintain system and replace cartridges.
Tube and adapter with NSF authorization and top quality, reduce TOC level and assure ultrapure water´s quality.
Optimized pretreatment (including PP fiber, KDF and active carbon cartridge), effectively protect RO membrane.
RO module with DOW´s membrane, ensure long life, stable operation and high desalinization rate.
Ultrapure cartridge with DOW´s top polishing resin, ensure ultrapure water´s quality up to 18.2 MΩ.cm, with the lowest TOC level.
Double wavelength (185&254nm) ultraviolet lamp module, restrain bacteria´s increase and reduce TOC.
MWCO 5000D ultrafiltration module, effectively eliminate endotoxin, and suitable for precise cell cultivating and IVF.
(0.45+0.1)µm double layer PES terminal disinfection filter, assure that terminal pure water is absolutely axenic.
Flow Schematic
Specifications
Model |
Standard |
Eliminating endotoxin |
Low TOC |
Synthesizing |
Built-in TOC module |
|
Super 10 |
Super 10F |
Super 10V |
Super 10FV |
Super-TOC10V |
Super-TOC 10FV |
|
Output-EDI water* |
10 liters/hour |
|||||
Output-ultrapure water |
Up to 2 liters/minute (when tank is full) |
|||||
Ultrapure water quality |
||||||
Resistivity (25°C) |
18.2MΩ.cm |
|||||
TOC* |
<10ppb |
<10ppb |
<3ppb |
<3ppb |
<3ppb |
<3ppb |
Bacteria |
<0.01cfu/ml |
|||||
Particle (>0.1µm) |
<1/ml |
|||||
Endotoxin |
N/A |
<0.001Eu/ml |
N/A |
<0.001Eu/ml |
N/A |
<0.001Eu/ml |
RNases |
N/A |
<1pg/ml |
N/A |
<1pg/ml |
N/A |
<1pg/ml |
DNases |
N/A |
<5pg/ml |
N/A |
<5pg/ml |
N/A |
<5pg/ml |
EDI water quality |
||||||
Resistivity (25°C) |
>5MΩ.cm |
|||||
TOC* |
<30ppb |
|||||
Silicon rejection rate |
>99.9% |
|||||
Feed water requirements |
Tap water, temperature: 5-45°C, pressure: 1.0-4.0Kgf/cm2 |
|||||
Dimension and weight |
Length×Width×Height: 545×470×639mm, 28Kg |
|||||
Electrical requirements |
AC200-240V, 50/60Hz |
|||||
Power |
240W |
|||||
Standard configuration |
Main body (Including 1 set of cartridge)+50 liters PE tank (TOC model: + built-in TOC module) |
Remarks:
*The value will be influenced by temperature and feed water´s quality.
Cartridges
Item no. |
Commodity |
Approximate replacement term / set |
D-PP1 |
Pretreatment cartridge |
2-6 months |
D-AK |
KDF+ granular active carbon mixed cartridge |
12 months |
D-AC2 |
Active carbon block cartridge |
6 months |
D-RO-100 |
100 GPD reverse osmosis membrane |
12-24 months |
D-RO-200 |
200 GPD reverse osmosis membrane |
12-24 months |
D-SF |
Water softener cartridge |
6 months |
D-EDI10-IP |
EDI module |
36 months |
D-Uvlamp-14W |
(254&185) nm wavelength uv lamp |
9000 hours |
D-Pocart4 |
Ultrapure polishing resin cartridge |
5000 liters pure water |
D-Ufcart |
Eliminating endotoxin uf cartridge |
- |
D-Tefit |
(0.45+0.1µm) terminal filter |
- |
Remarks:
*The quality of inlet water will effect cartridge’s life.
*When inlet water’s TDS>200ppm, Replace term of filter will be suggested to decrease, or outside pre-filter is added. Or water quality and life of ultrapure cartridge will be affected.
HHitech-Products
Designing and manufacturing under ISO certification, top quality controlling commitment, ensure compliance with CE standards of EU, guarantee completely meeting with the highest grade I water standards of ASTM, CAP, CLSI, EP and USP.
HHitech-Service
As a responsible manufacturer with rich experience, operating in good faith, and the concept of common development, adhering to the customer-oriented and customer-needs, HHitech promises to provide professional comprehensive pre-sales and after-sales service in the whole business.
■ 12 months warranty except for consumables.
■ Timely guide for installation, usage and maintenance.
■ Free and continuous upgrade service for sold products.
http://www.hhitechlabwater.com/